Panasonic TZ-PCD3000 - Manual (Page 8)

Troubleshooting
Check that the batteries are installed with the correct polarities (+and -).
The batteries are depleted: Replace them with new ones.
Point the remote control unit at the remote control sensor and operate.
Operate the remote control unit at a distance of not more than 23 feet (7 meters) from the remote control sensor.
Remove any obstacles between the remote control unit and remote control sensor.
Make sure the remote control is in the proper component mode (i.e. CABLE, TV,VCR,AUDIO).
Symptom Remedy
No power Check that the AC power plug is securely plugged into the power outlet.
No reception
Check that equipment is connected properly.
Check that the cable wire is connected properly.
No picture
Check that equipment is connected properly.
Check if the channel is available.
Make sure the TV power is turned on.
Make sure the proper input on the TV (TV/Video) is selected.
If your setup includes a VCR and/or stereo, make sure you have properly connected them to the Digital CATV Terminal unit.
Make sure your TV is tuned to the proper output channel (3 or 4).
No sound
Properly plug your television and Digital CATV Terminal unit into an electrical outlet.
Make sure all cables are properly connected.
Make sure the TV power is turned on.
If your setup includes a VCR and/or stereo, make sure you have properly connected them to the Digital CATV Terminal unit.
Make sure your TV is tuned to the proper output channel (3 or 4).
Make sure the volume is turned up.
Make sure the TV is not in “MUTE” mode.
Distorted picture
Make sure all cables are properly connected.
Adjust the TV to channel 3 or 4.
No color
Make sure the current TV program is broadcast in color.
Adjust the TV color controls.
The remote control is
not responding
S0704-0
Printed in USA
Panasonic Consumer Electronics Company ,
Division of Matsushita Electric Corporation of America
One Panasonic Way Secaucus New Jersey 07094
2004 Matsushita Electric Corporation of America. All Rights Reserved. C