Primera Technology RW-12 - Manual (Page 5)

5
Section 3: Attach Label Stock
1. Locate a suitable core on which to rewind labels. The core should be equal to or
less than the width of the liner width.
2. Remove the Chuck Support Bar by unscrewing the thumb screw at the base.
3. Place the core on the chuck.
4. Place the Adjustable Label Guide on the chuck. Push it tight against the core.
5. Tighten the Chuck Tension Knob so that the core and the guides do not move.
6. Reattach the Chuck Guide Bar to the base with the thumb screw.
7. Set the printer on the stability stand. Follow these guidelines:
• The feet of the printer should set anywhere on the lower portion of the stand.
• Line up the edge of the labels exiting the printer with the Fixed Label Guide on
the rewinder by moving the printer from side to side.
• The distance from the printer output to core is adjustable according to user
preference. Start with the front of the printer in the middle of the lower portion of
the stand.