Panasonic AJ- DCP - Manual (Page 35)

35
Setup Menus
781 IN IMP SEL
0000
0001 600
HIGH
For setting the impedance of the analog audio input.
0: 600
Ω
1: High impedance
<Note>
Regardless of the setting selected here, the impedance is set to 3 k
Ω when
–60 dB has been selected as the menu item No.701 to 704 (CH1 to CH4
IN LV) settings.
AUDIO
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining denotes the factory mode.
A02 P.ON LOAD
0000
0001 OFF
ON
For setting whether to change the setup menu settings to the user’s initial
settings when the power is turned on.
0: The settings are not changed.
1: The settings are changed.
MENU
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining denotes the factory mode.
780 AUD OUT SEL
0000
0001
0002
LINE
CH1/2
CH3/4
For setting the output sound of the analog audio output connectors.
0: All the output connectors are used as the main line output.
CH1 connector = CH1 sound
CH2 connector = CH2 sound
CH3 connector = CH3 sound
CH4 connector = CH4 sound
1: The CH1 and CH2 output connectors are used as the main line output,
and the CH3 and CH4 output connectors are used as the monitor output
connectors.
CH1 connector = CH1 sound
CH2 connector = CH2 sound
CH3 connector = Monitor L (CH1, CH2, CH1+CH2) sound
CH4 connector = Monitor R (CH1, CH2, CH1+CH2) sound
2: The CH1 and CH2 output connectors are used as the main line output,
and the CH3 and CH4 output connectors are used as the monitor output
connectors.
CH1 connector = CH3 sound
CH2 connector = CH4 sound
CH3 connector = Monitor L (CH3, CH4, CH3+CH4) sound
CH4 connector = Monitor R (CH3, CH4, CH3+CH4) sound