ParkerVision USB1500 - Manual (Page 25)

27 27
USB1500
Wireless PC LAN Adapter
®
Chapter 5 - Troubleshooting - Continued
5.4 Problems Communicating With the Computer
PROBLEM CORRECTIVE ACTION
The ParkerVision USB Wireless
LAN Adapter client cannot
communicate with the other
computer on the Ethernet when
the Infrastructure mode is
confi gured.
Make sure that the AP and the associated computer are on.
Make sure your computer and the AP use the same SSID.
Make sure both computers are associated with the Access Point.
Use the Windows Ping Command to test communications to the access point’s IP
Address. Consult your Access Point documentation for the address settings. If you
can Ping the Access Point, you should then attempt to Ping the second computer. The
IPCONFIG command will display a computer assigned IP Address when entered from a
Windows Command Prompt.
Use the Site Survey utility to verify operating radio channel has low interference. Change
the AP and all the stations within the BSS to another radio channel if interference is high.
Make sure that the computer and the AP share the same security option and key.
ParkerVision Status Utility
Button displays No Signal.
Move your computer closer to the AP within the transmission range.
There is too much radio
interference (for example
microwave oven or cordless
telephone) around your
wireless network.
Relocate or reduce the radio interference.