Panasonic SC-HT990 - Manual (Page 14)

RQT8
72
2
Si
mp
le
S
etu
p
14
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage
which can severely damage the remote control.
Remove the batteries if the remote control is not going
to be used for a long period of time. Store in a cool, dark
place.
∫ Use
Aim at the remote control signal sensor (
➜ page 15),
avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
The QUICK SETUP screen assists you to make necessary settings.
To display the picture from the main unit, turn on your television and change its video input mode (e.g.
VIDEO 1, AV 1, etc.).
≥ To change your television’s video input mode, refer to its operating instructions.
≥ This remote control can perform some basic television operations (
➜ page 37).
To change these settings later
Select “QUICK SETUP” in the “Others” tab (
➜ page 30).
STEP
6
Preparing the remote control
R6/LR6, AA
1
3
2
Remote control Batteries
Insert so the poles ( i and j) match those in the
remote control.
≥ Do not use rechargeable
type batteries.
STEP
7
Performing QUICK SETUP
ENTER
RETURN
DVD
SETUP
1 Turn on the unit.
2 Select “DVD/CD”.
3 Press and hold to show
the QUICK SETUP
screen.
4 Follow the messages
and make the settings.
5 Press to finish QUICK
SETUP.
6 Press and hold to exit.
Select
Register
ENTER
Preparing the re
mote
contr
o
l / P
e
rf
orm
ing Q
U
ICK SETUP
HT540En.book Page 14 Monday, February 27, 2006 8:15 PM