Panasonic PT-D7500U - Manual (Page 39)

39
Powering up the projector
Connect the supplied power cable.
(120 V AC, 50 Hz/60 Hz)
Press the “I” marked side of the MAIN
POWER switch to turn on the power.
The power indicator lamp on the projector will flash
in red. After a short period, the indicator will
illuminate and the projector will enter standby
mode.
Press the “l” button. [on the main unit
or the remote control]
The power indicator lamp illuminates in green and
soon the image is projected on the screen.
Making adjustment and
selection
Roughly adjust the focus of the lens.
(Refer to page 41.)
Press the LENS button on the main unit or the
remote control unit to display a focus adjustment
screen. Pressing
buttons to adjust
the image into focus.
Select and set the projection scheme.
(Refer to page 70.)
Select the input signal by pressing the
input selector button to toggle through
RGB1, RGB2, VIDEO, S-VIDEO and
AUX. [on the main unit or the remote
control]
Adjust the tilt of the main unit in front
and rear or right and left.
(Refer to page 18.)
• If the projector is powered up at about 0˚C, a warm-
up period of approximately five minutes may be
necessary to start projection.
The temperature monitor (TEMP) lamp flashes during
the warm-up period.
When the warm-up is completed, the temperature
monitor (TEMP) lamp turns off and the image is
projected on the screen.
• If this happens, raise the surrounding temperature to
0°C or higher and then turn the main power “on” and
turn the power “on” (|).
• The AUX button is disabled when an optional input
module is not connected.
Note
AUTO
SETUP
RGB 1
VIDEO
MENU ENTER
LENS
S-VIDEO SHUTTER
RGB 2 AUX
POWER ON OFF
RGB 1 RGB 2 AUX
MENU
STD
LENS
OSD 1
4
7
2
5
8
3
6
9
0 NEXT USER
LIGHT ID ALL
ASPECT
ID SET
Projector Computer
Numetric
BRIGHT CONTRAST
ON SCREEN
SYSTEM SEL
FUNC 1
D.ZOOM
ENTER
PAGE UP
PAGE DOWN
VIDEO SHUT S- VIDEO
FREEZE
SHUTTER
AUTO SETUP
LASER ON/OFF
Press the LENS button two or three
times to adjust the lens shift. (Refer to
page 41.)
Press the AUTO SETUP button if the
input signal is RGB signal. [on the
main unit or the remote control]
Fit the image size to the screen size.
(Refer to page 41.)
Press the LENS button twice and adjust the zoom
of the lens on the lens zoom adjustment menu.
Press the LENS button and adjust the
focus of the lens on the lens focus
adjustment menu.
Display the zoom adjustment menu
again and adjust the zoom of the lens
to fit the image size to the screen size.
(Refer to page 41.)
Projection