Patton electronic PATTON 2603 - Manual (Page 33)

Hardware installation 33
Models 2603, 2621, and 2635 Getting Started Guide 3 • Initial Configuration
4. Re-assemble the case.
The interface cable has been installed, go to section “Installing the AC power cord” on page 34.
Installing an interface cable on the IPLink 2635’s V.35 interface port
The IPLink Model 2635 comes with a V.35 interface presented on a DB-25 female connector (see
figure 10 ).
The Model 2635 V.35 (DB-25) interface is configured internally as a DCE. However, when using the Patton
cable with the 2635, the V.35 interface at the M/34 end of the cable is a DTE (see
figure 11 ). In other words,
the Patton DB-25 to M/34 cable is a sync null modem cable.
Figure 10. Rear view of the 2635 showing location of Ethernet and V.35 connectors
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
MDI-X
Crossover
10/100
Ethernet Power
MDI-X
Crossover
10/100
Ethernet
WA N
X.21 Interface
V.35 Interface
Power
V.35 Interface connector
(DB-25)
Ethernet connector
(RJ-45)