Panasonic RC-CD350 - Manual (Page 3)

3
• Avoid using or placing this unit near sources of heat.
• Avoid cuts, scratches, or poor connections in the AC mains lead, as they may result
in possible fire or electric shock hazard. Also, excessive bending, pulling or splicing
of the cord should be avoided.
• Do not unplug the AC mains lead by pulling on the cord. To do so may cause
premature failure or a shock hazard.
• Do not operate this unit on AC power in a bathroom, as a potential shock hazard
may result.
• If the unit is not used for a long period of time, remove the batteries to prevent
potential damage due to possible battery leakage.
• Do not heat, disassemble, or allow contact with flame or water.
• Do not peel off the covering and do not use if the covering has been peeled off.
Battery mishandling can cause electrolyte leakage which can damage items the fluid
contacts and may cause a fire.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any part of your body.
• Do not use irregularly shaped CDs.
• Do not use non-specification discs.
• Do not use CDs printed with label printers available on the market.
• Do not use CDs with labels and stickers that are coming off or with adhesive
exuding from under labels and stickers.
Note on CD-R/RW
This unit can play CD-R and CD-RW recorded with CD-DA. Use an audio recording
disc and finalize* it when you finish recording. The unit may not be able to play some
discs due to the condition of the recording.
* A process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.
Note
Specifications are subject to change without notice.
Mass and dimensions are approximate.
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth
carefully.
Precautions
Cautions
Batteries
CDs
Specifications
Frequency range
FM:
AM:
Sampling frequency
Decoding
Beam source
Number of channels
Wow and flutter
D/A converter
Speakers
Power requirement
Memory back-up
Dimensions (W x H x D)
Mass
87.5 to 108.0 MHz (50 kHz step)
522 to 1629 kHz (9 kHz step)
44.1 kHz
16 bit linear
Semiconductor laser (wavelength 780 nm)
2 channel, stereo
Less than possible measurement data
1 bit DAC
4.5 cm, 6 Ω x 2
AC 230-240 V, 50 Hz
Power consumption: 11 W
9 V (One 6F22/6LR61, 006P battery)
266 x 149 x 137 mm
1.47 kg without battery (For the United Kingdom)
1.43 kg without battery (For Australia and New Zealand)
Maintenance
Power consumption in standby mode: 2.3 W