Prima PJE020 - Manual (Page 3)

IMPORTANT
THE JUICE EXTRACTOR IS EQUIPPED WITH A SAFETY INTERLOCK SWITCH. THIS IS FITTED TO PREVENT
THE MOTOR FROM BEING ACTIVATED WHILE THE MACHINE IS DISASSEMBLED. THE MOTOR WILL NOT
RUN UNLESS THE REMOVABLE TRANSPARENT COVER IS ON SECURELY AND LOCKED INTO PLACE
WITH THE SAFETY LOCKING HANDLES.
ASSEMBLY
Before first use it is a good idea to familiarise yourself with the assembly/disassembly of the
unit.
ASSEMBLY
1. The appliance should be unplugged from the mains before assembly or disassembly.
2. Place the pulp container under the nozzle on the left of the machine. Place the juice
container under the nozzle on the right of the machine.
3. Attach the residue container onto the main body and clip the filter net into place.
4. Attach the top transparent cover and close and place the juicer stick in the food chute.
5. Make sure the housing unit is locked with the safety lockers in place by hooking them
onto the top cover and pushing them downwards until they clip in place.
6. The juicer will not work for safety reasons if the safety lockers are not locked in place
correctly.
DISASSEMBLY
1. Remove the juicer stick and the pulp and juice containers.
2. To remove the upper body pull both safety lockers outwards from the bottom. Release
and lift off the top cover.
3. Lift the filter net off by gently pulling upwards.
4. Lift of the Residue container.
SETTINGS
There are 2 settings 1 and 2
Setting 1 is low speed and is usually best for soft fruits such as plums and peaches (Please
remove the stone before trying to juice!)
Setting 2 is faster and is usually best for harder fruits such as apples and carrots.
PLEASE NOTE: There is a temperature safety device installed in the machine. If the machine
becomes too warm the machine will automatically shut down until the motor has cooled to the
correct temperature. (This usually takes about 15 minutes). To prevent this from happening
please do not use the machine continually for more than one minute at a time.