Powermatic DS20 - Manual (Page 7)

7
To operate the mitre gauge, loosen lock handle (J)
and move the body of the mitre gauge (K) to the
desired angle. The mitre gauge body is set to stop
at 0 degrees and 45 degrees left or right. To move
the gauge beyond these points, the stop link (L)
must be flipped out of the way.
FIGURE 2
MAINTENANCE
Your DS20 Sander requires minimal maintenance.
Periodically, make sure table trunnions and rack
(M & N, Figure 2) are properly greased with a good
grade, non-hardening grease.
The table surface should be kept clean and free of
rust for best results. Although some users prefer
a wax coating, white talcum powder rubbed in vig-
orously once a week will fill casting pores and form
a moisture barrier. This method allows rust rings
to be easily wiped from the surface. Important also
is the fact that talcum powder will not stain wood
or mar finishes as wax pickup does.
OPTIONAL ACCESSORIES (Model DS20)
6295599 Sanding Paper 20", 100 grit.
6295661 Sanding Paper 20", 80 grit.
6295662 Sanding Paper 20", 60 grit.