Procom MN060HBA - Manual (Page 17)

1 7
SPECIFICATIONS
Btu(available)
Gas Type
Ignition
Pressure Regulator setting
Inlet Gas Pressure* (inches of water)
Maximum
Minimum
Dimensions, Inches (HxWxD)
Heater
Carton
Weight (pounds)
Heater
Shipping
MN100HBA
6,000/10,000
Natural Only
Piezo
3
"
W.C
10.5
"
4
"
19-1/8 Ч 14-1/8 Ч 6-3/8
22 Ч 16-3/4 Ч 8-1/8
13
16
Note: Dimensions listed are outer most points on the heater (includes control knobs and grill).
* For purposes of input adjustment.
EQUIPMENT SHUTOFF VALVE
For all models. Equipment shutoff
valve with 1/8
"
NPT tap.
TECHNICAL SERVICE
You may have further questions
about installation, operation, or
troubleshooting. If so, contact
PRO-COM through the phone num-
ber 1-877-886-5989.The information
is listed on the front of manual.
SERVICE HINTS
When Gas Pressure Is Too
Low
Pilot will not stay lit
Burner will have delayed ignition
Heater will not produce specified
heat
When Gas Quality Is Bad
Pilot will not stay lit
Burner will produce flames and
soot
Heater will backfire when lit
You may feel your gas pressure is
too low or the gas quality is poor. If
so, contact your local natural gas
supplier.
REPLACEMENT PARTS
Note: Use only original replacement
parts. This will protect your warranty
coverage for parts replaced under
warranty.
PARTS UNDER WARRANTY
Contact authorized dealer from
whom you purchased this product.
If they are unable to supply original
replacement part(s), call the num-
ber on the front of this manual. When
contacting your dealer or PRO-COM,
have ready:
your name
your address
model and serial numbers of
your heater
how heater was malfunctioning
type of gas used (propane/LP or
natural gas)
purchase date
warranty card
Usually, we will ask you to return the
defective part to the factory.
PARTS NOT UNDER
WARRANTY
Contact authorized dealers of this
product. If they can’t supply original
replacement part(s), contact PRP-
COM through the phone number 1-
877-886-5989.
MN100TBA
10,000
Natural Only
Piezo
3
"
W.C
10.5
"
4
"
19-1/8 Ч 14-1/8 Ч 6-3/8
22 Ч 16-3/4 Ч 8-1/8
14
17
FLOOR MOUNTING STAND
Models MN060HBA,MN100HBA,
MN100TBA
For locating heater on the floor away
from a wall. Complete installation
instructions provided with floor
mounting stand.
ACCESSORIES
Purchase these heater accesso-
ries from your local dealer. If they
can not supply these accessories,
contact PRO-COM for information.
You can also write to the address
listed on the front of this manual.
MN060HPA
6,000
Natural Only
Piezo
3
"
W.C
10.5
"
4
"
19-1/8 Ч 14-1/8 Ч 6-3/8
22 Ч 16-3/4 Ч 8-1/8
12
15