Proxim Stratum - Manual (Page 3)

System
Ethernet Architecture
Radio Data Rate
Network Topologies
Number of Nodes per Cell
Range (Line-of-Sight
with high gain antennas)
Bandwidth Management
ISP Privacy Mode
Link Security & Cell Isolation
Throughput Quality
Ethernet
Physical Layer Connection
Ethernet Frame Types
Learning Bridge Addresses
Network Management
Remote Access
Parameters
Firmware Upgrade
Configuration Security
Approvals
FCC
ETSI
Safety
Radio
Frequency Band
Radio Type
Modulation
Frequency Channels
Transmit Power
Receiver Sensitivity
Transparent bridge
10 Mbps, half duplex
Point-to-Point for linear topologies
Point-to-Multipoint for cellular topologies
32
12 miles (FCC rules)
5 km (ETSI rules)
Configure maximum packets to send from each node per polling cycle
Disable multipoint client-to-client bridging
Transec: 64,000 code channels with continuously changing codes
Packet re-transmission with Forward Error Correction coding for missing
or errored packets
10BaseT, half duplex setting, RJ-45 connector
IEEE 802.3, Ethernet II
Up to 2000 MAC addresses supported per network segment
In-band via HTTP
Configuration, Performance
Flash downloadable in the field
Password authentication
Part 15, subpart B, class B digital device; Part 15.247
ETS 300-328
UL-CUL, EN-60950, CE Mark
2400-2483.5 MHz. Frequency selections vary by country.
Direct Sequence Spread Spectrum
Continuous Phase Modulation
11 channel selections
+12 dBm (models 2002 & 2003), 0 dBm (model 2001)
-81 dBm