PEAK-System Technik PCAN-DONGLE IPEH-002019 - Manual (Page 9)

PCAN-Dongle (ISO) – User Manual
+5 Volts at the CAN connector:
Figure 2:
PCB PCAN-Dongle (bottom side):
JP9, 2-1 (as shown) → pin 1
JP9, 2-3 → pin 9
Figure 3:
PCB PCAN-Dongle ISO (top side):
Pos. R11 bridged → pin 1
3. For reassembly place the PCB overhead onto the top part of
the case. Make sure that the cable is lying in the side cut-out
with the strain relief inside the case, and that the LED is
placed in the corresponding hole of the top part of the case.
4. Push the bottom part of the case onto the top part (the
latches click in).
9