PEAK-System Technik PCAN-DONGLE IPEH-002019 - Manual (Page 15)

PCAN-Dongle (ISO) – User Manual
Figure 5: Selection of hardware resources
3. Enter the port address and the interrupt of the used parallel
interface established before (see section above).
4. Confirm your input with OK.
In the dialog box "Connect to CAN hardware" make further settings
(baud rate and CAN message filter) for the created hardware entry.
If you need further help after the program start, use the online help
provided with the program (key [F1]).
4.2 Getting Started under DOS
4.2.1 Information about the Parallel Interface
You need information about the used interrupt and port address of
the parallel interface. It can be determined with the MS-DOS tool
MSD (MSD.EXE in the DOS directory).
The following table gives an overview of the common port
addresses and interrupts for the parallel port at the PC.
15