PEAK-System Technik PCAN-DONGLE IPEH-002019 - Manual (Page 5)

PCAN-Dongle (ISO) – User Manual
CAN connection 9-pin Sub-D male, pin assignment according to
CiA recommendation DS102
Galvanic isolation up to 500 V for the CAN interface (only PCAN-
Dongle ISO)
Power supply (5 V) via cable with T-piece for keyboard
connector (DIN or PS/2)
Support for operating systems Windows (98 SE, ME, 2000 SP4,
XP), Linux, and DOS
Note: This manual describes the use of the PCAN-Dongle with
Windows and DOS. You can find device drivers for Linux and
the corresponding information on PEAK-System's website
under http://www.peak-system.com/linux .
1.2 System Requirements
The following prerequisites must be given, so that the PCAN-Dongle
can be used properly:
An empty parallel port (Sub-D, 25 pins) at the PC, capable of
interrupts
Operating system Windows (98 SE, ME, 2000 SP4, XP), Linux, or
DOS
1.3 Scope of Supply
The scope of supply normally consists of the following parts:
Adapter PCAN-Dongle (case with two ports and a cable with T-
piece for DIN or PS/2 keyboard connector)
CD-ROM with software (drivers, utilities), programming
examples, and documentation
5