Panasonic BT-LH1760E - Manual (Page 9)

9
POWER switch
Switches the power supply ON/OFF. When the power is ON, the LED (green) lights up.
INPUT SELECT buttons
Selects the signal input line. The green LED light above the button indicates the selected input signal.
VIDEO
: Video input
SDI1 : Serial digital interface input (HD/SD compatible)
SDI2 : Serial digital interface input (HD/SD compatible)
YP
B
P
R
/RGB : Analog component (YP
B
P
R
) or RGB input. Also compatible with PC input RGB.
* When using PC Input, select “RGB-COMP.” from “YP
B
P
R
/RGB” in the “INPUT SELECT”
menu ( J page 30).
DVI-D : DVI-D input (HDCP compatible)
* When using PC Input, select “DVI-COMP.” from “DVI-D” in the “INPUT SELECT” menu
( J page 30).
MENU, FUNCTION buttons
Use these buttons to display menus, select and adjust settings and confirm menu selections.
MENU
: Press to open a menu, exit a menu or return to a previous menu.
/FUNCTION1 : Moves the cursor downwards and selects items.
It also confirms a menu item assigned to FUNCTION1.
/FUNCTION2 : Moves the cursor upwards and selects items.
It also confirms a menu item assigned to FUNCTION2.
ENTER/FUNCTION3 : Press to confirm a setting or to open a submenu.
It also confirms a menu item assigned to FUNCTION3.
FUNCTION4 : Confirms a menu item assigned to FUNCTION4.
FUNCTION5 : Confirms a menu item assigned to FUNCTION5.
* When the control lock is on, the key mark appears and FUNCTION does not operate.
Picture adjusting knob
PHASE 0 - 60 (30)
CHROMA 0 - 60 (30)
BRIGHT 0 - 60 (30)
CONT [CONTRAST] 0 - 60 (50) / B.LIGHT [BACKLIGHT] 0 - 60 (60)
( ) denotes factory preset values.
Turn or press this knob to display and adjust menu settings. Press the knob a second time to save settings.
When values are changed from the factory defaults, the LED above the knob (amber) lights.
Settings are loaded when the monitor is turned on. The settings are saved when the knob is pressed, or when
10 seconds have elapsed after they have been changed. However, operating changes cannot be made in the
following conditions.
* When the control lock is on, the key mark appears and setting values cannot be changed (
J page 34).
* When the MONO function is ON ( J page 20), [PHASE] and [CHROMA] operations are disabled.
* When using “RGB-COMP.” input or “DVI-COMP” input, [PHASE] and [CHROMA] operations are disabled.
* While operating HV DELAY (
J page 24) (when set to any other setting than OFF), [BRIGHT] operation is disabled.
Volume knob
Turn this knob to adjust speaker and headphones volume.
Speaker
The speaker reproduces audio input from the AUDIO input terminal or SDI terminal (embedded audio).
* Connecting headphones to the HEADPHONES output connector turns off the speakers.
Front panel
Controls and Their Functions
(continued)