Panasonic TC-32LX60C - Manual (Page 29)

29
F
AQs, etc.
Frequently
Asked Questions
Maintenance
If there is a problem with your TV please refer to the table below to determine the symptoms, then carry out the
suggested check. If this does not solve the problem, please contact your local Panasonic dealer, quoting the model
number and serial number (both found on the rear of the TV).
Noisy Sound Snowy Picture
Normal Sound Multiple Images
Noisy Sound Interference
No Sound Normal Picture
No Sound No Picture
Normal Sound No color
Weak or No Sound Poor or Distorted Picture
Weak, Wrong or No Sound Normal Picture
Cannot operate with the remote control.
There may be red spots, blue spots,
green spots and black spots on the
screen.
The main unit is hot.
Symptoms
Checks
Picture Sound
•
Antenna location, direction or connection.
•
Antenna location, direction or connection.
•
Electrical appliances.
Cars / Motorcycles.
Fluorescent
lights.
•
Volume level.
Sound mute switched on.
STEREO/SAP/MONO
•
TV set to AV mode.
Not plugged into wall outlet.
Not switched on.
Picture / Sound controls set at minimum levels.
•
Color controls set at minimum levels.
Weak signal.
•
Retune Channel (s).
•
Sound reception may have deteriorated.
Set STEREO/SAP/MONO setting to SAP or MONO until reception improved.
•
The battery/ies is/are exhausted.
The batteries’ polarity is wrong.
The remote control sensor is exposed to strong light from a fluorescent lamp, etc.
•
This is a characteristic of liquid crystal panels and is not a problem. The
liquid crystal panel is built with very high precision technology giving you
fine picture details. Occasionally, a few non-active pixels may appear on the
screen as fixed points of red, blue, green, or black.
Please note this does not affect the performance of your LCD.
•
The main unit radiates heat and some of the parts may become hot. This is
not a problem for performance or quality.
Set up in a location with good ventilation.
Do not cover the ventilation holes of the TV with a tablecloth, etc., and do
not place on top of other equipment.
“Control with HDMI” function does not
work
•
Switch the TV unit on again with the equipment on.
•
Set “Control with HDMI” to “Off”, then set to “On” again. (p. 19)