Primera Technology PN 510725-121304 - Manual (Page 2)

This sheet describes the installation and use of the CD-R Business Card
Adapter Kit for the Disc Publisher and the AutoPrinter (referred to
hereafter as the “Publisher”).
NOTE: The Business Card Adapter Kit is designed to work with the
Publisher. This will not work with other CD Printers or Duplicators.
SECTION I: INSTALLATION
1. Make sure that in this box you have the following items:
•
CD Business Card/ Mini CD 80mm Input Bin
•
“Hockey Rink” Card Input Bin
•
Output Ring
•
CD Business Card Tray Template Assembly
•
Mini Disc 80mm and “Hockey Rink” Tray Template Assembly
•
9 Sample Discs
2. Remove original 120mm Input Bin and place the appropriate Card/
Mini Disc Input Bin on the right side of the Publisher with the
opening in the bin to the rear.
If the opening in the bin is not
toward the rear, the Robotic Disc Transporter will not be
able to pick from the bin.
Figure 1: Input Bins
3. Place Output Ring in the center of the Output Bin on the left side
of the Duplicator as shown in Figure 3.
4. With the Front Cover of the Publisher closed, press the Cartridge
Button. The Printer Tray will open. Open the Front Cover and
install the appropriate Printer Tray Template in the Printer Tray
as shown in Figure 3. The front of the Template has molded tabs
that fit into locating slots found toward the front of the Printer
Tray. When properly installed, the metal clamp moves forward to
hold the card in place as the Printer Tray retracts into the printer.
Figure 3: Adapter Kit “Hockey Rink” Card Input Bin CD Business Card/ Mini CD
Input Bin
Rear Opening
For Arm
“Hockey Rink” and Business
Card Template
Mini Disc Template
Figure 2: Printer Tray Templates
Output
Ring
Input Bin Printer Tray
Template
Front Cover
Cartridge
Button