Panasonic AW-RP400 - Manual (Page 29)

Pan/Tilt Control Panel AW-RP400
AW-RP400
29
Menu settings
$ List of menu items and settings
PRIORITY MASTER, SLAVE MASTER
DIRECTION PAN
TILT
ZOOM
NORMAL, REVERSE NORMAL
FOCUS
IRIS
ROTATION
TILT RANGE 190°, 300° 190°
SPEED WITH ZOOM POS. OFF, 1, 2, 3 OFF
MEMORY LENGTH 60s, 120s, 300s, 600s 60s
PRESET SPEED 1 to 25 25
IRIS CONTROL BOTH, RP400, CB400 BOTH
ROTATION SWITCH ROTATION, FOCUS, ZOOM, IRIS ROTATION
OPTION SWITCH A
B
C
D NOT USE, DEF, WIP, HEATER/FAN, NOT USE
E LAMP, OPTION, ND, EXT, AF
F
G
H
CONTROL SELECT MODE INTERLOCK, UN-INTERLOCK INTERLOCK
BUZZER OFF, ON ON
AUTO RUN START No. 1 to 50 1
END No. 1 to 50 50
INTERVAL 1s to 30s 1s
OPERATE STOP, RUN STOP
SD CARD STORE, LOAD – – –
Menu item Setting Description Initial value
PRIORITY (MASTER/SLAVE)
When two AW-RP400 pan/tilt control panels have been connected, the priority of the CONTROL SELECT buttons is to be
set.
When MASTER is selected as the setting, the master AW-RP400 has priority; when SLAVE is selected, the slave AW-RP400
has priority.
If the AW-RP400 control panel with a high priority has selected the pan/tilt heads, which were selected by the AW-RP400
control panel with a low priority, the CONTROL SELECT button lamps on the AW-RP400 control panel with the low priority
start flashing to indicate that the control rights have been ceded to the other control panel. This setting is performed using the
master AW-RP400 control panel.