Powerware BladeUPS none - Manual (Page 18)

INSTALLATION
EATON Powerware ® BladeUPS ® EBM User's Guide S 164201650 Rev 2 www.powerware.com 14
EBM Setup
The Powerware BladeUPS EBM comes with all hardware required for
installation in a standard EIA or JIS seismic rack-mount configuration
with square and round mounting holes. The rail assemblies adjust to
mount in 48-cm (19-inch) racks with front to rear rail distances from
61 to 76 cm (24 to 30 inches) deep.
Checking the EBM Accessories
Verify that the following items are included with the EBM:
S
EBM front cover
S
Mounting brackets and fasteners (if not already installed):
- (2) mounting brackets
- (4) 6-32 flat-head screws
S
Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (2) rear hold-down brackets
- (12) hex-head screws
- (4) U-shaped 10-32 clip nuts
S
This user's guide