PACKARD BELL COMPASSEO 600 - Manual (Page 16)

Page 16 of 18
Working with Your Navigation Map
Zooming In and Zooming Out on the Map
• Tap on the Zoom In / Zoom Out button on the right side of the screen. Each tap will increase / decrease
the scale. To check the current scale, check the Zoom Scale at the bottom left corner of the map.
Panning of the Map
• Sometimes, you may want to move the map to view a location which is outside the viewable screen. To
do this, you need to pan the map.
• Tap AND hold on the map screen and drag towards the desired direction i.e. to the left or right etc.
You can only pan in the Map Mode.
Switching Between the Navi Mode and Map Mode
• The Navi Mode is a dynamic map which you display your route as you navigate towards your destination.
Simulation is also carried out in this mode.
• The Map Mode is simply a street directory where you can view a stationary map.
• To switch between these two modes, tap anywhere on the map to open the pop-up menu.
• Tap on the ‘NAVI ON’ / ‘NAVI OFF’ button.
The button would display the next state that you are toggling to. For example, if you are in Navi Mode, the
button would display ‘NAVI OFF’ which allows you to switch off Navi Mode and switch to Map Mode.
Switching Between the Night Mode and Day Mode
• You can choose to view the map in Night / Day mode.
• Tap anywhere on the map to open the pop-up menu.
• Tap on the ‘DAY MODE’ / ‘NIGHT MODE’ button. The button would display
The button would display the next state that you are switching to.
Switching Between the 2D and 3D Mode
• You can view the Navigation Mode in 2D or 3D.
3-Dimension is only available in Navigation Mode (NAVI ON). In Map Mode (NAVI OFF) you can only view in 2-
Dimension.
• Tap anywhere on the map to open the pop-up menu
• Tap on the ‘2-DIMENSION’ / ‘3-DIMENSION’ button to switch to the next mode.
The button would display the next state that you are switching to.