Patton electronic Serial G.SHDSL Bridge/Router 3087 - Manual (Page 5)

Model 3087 Quick Start Guide 5
4.0 Log onto the web management interface
You will now access the web management graphical user interface (GUI) to configure the ipRocketLink using a
standard web browser (such as Internet Explorer or Netscape browser).
1. At your PC, open a web browser and enter the IP address you assigned to the ipRocketLink’s Ethernet LAN
port in step 2 of section
2.2 “Modify the IP address” on page 3.
2. Log in to the web management home page using the username superuser and the password superuser.
Figure 3. Model 3087 web management home page
5.0 Connect the G.SHDSL Port
1. Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
2. Plug one end of the cable into the (yellow) RJ-11socket (labelled DSL) on the ipRocketLink Integrated
Access Device.
3. Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
4. When a DSL link is established the front-panel WAN LINK LED will turn on.
6.0 Connect the serial port
Your ipRocketLink is equipped with one of the following serial WAN ports for connection to an NTU:
• V.35 (M/34 or DB-25)—Model 3087/RIC/EUI
• X.21 (DB-15)—Model 3087/RID/EUI
• T1/E1(RJ-48C and dual BNC)—Model 3087/RIC/EUI