Front panel, Pec u, Pico macom inc – Pico Macom TA-52 User Manual
Page 5
PICO MACOM INC.
12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511 • FAX (818) 834-7197
4
Front Panel
1.
UHF or Combined: Connect UHF or
UHF/VHF antenna to this port.
2.
VHF/FM:
Connect VHF antenna to this port
3.
Separate or Combined:
If using separate VHF and UHF antennas, position
slide switch on "Separate". If using UHF/VHF broad-
band antenna, position slide switch on "Combined"
4.
-10 dB:
Provides 10 dB attenuation to low-band input.
5.
FM Trap:
Provides blocking of FM signal if required.
6.
Gain Adjust:
Potentiometer provides for R.F. low-band
gain adjustment
7.
Tilt:
Potentiometer provides for low-band slope adjustment
8.
-10 dB:
Provides 10 dB attenuation to hi-band input.
9.
-10 dB:
Provides 10 dB attenuation to uhf-band input.
F E A T U R E S
10.
Gain Adjust:
Potentiometer provides for R.F. hi-band gain adjustment
11.
Gain Adjust:
Potentiometer provides for R.F. uhf-band gain adjustment
12.
Tilt:
Potentiometer provides for hi-band slope adjustment
13.
UHF/VHF Output:
Connect this port to distribution system
14.
Monitor -20 dB:
Used to monitor output signal
15.
Power LED:
Indicates when amplifier is on.
16.
Fuse:
Replace with 1 amp 250 volt fuse.
17.
On/Off:
Power on or off switch
18.
Power Cable:
The three prong type power plug connects to a 120 Vac,
60 Hz electrical outlet.
-10DB
IN
FM TRAP
0DB
OUT
-10DB
0DB
ATTENUATOR
-10DB
0DB
ATTENUATOR
GAIN
INPUT
VHF/FM
SEPARATE
COMBINED
UHF OR
COMBINED
GAIN
GAIN
TILT
TILT
LO BAND
HI BAND
UHF
UHF/VHF OUTPUT
MONITOR-20DB
•
™
®
pec
u
UHF/VHF/FM
DISTRIBUTION AMPLIFIER
MODEL TA-52
CAUTION
DO NOT REMOVE SCREWS
FUSE
PL
1A
ON
117V
40W
4
5
6
7
3
1
2
8
10
12
11
9
13
14
15
16
17
18