Panasonic KX-FPG377 - Manual (Page 65)

8. Programmable Features
63
6. Press {SET}.
7. Press {MENU}.
Code #42: Setting the message alert
MESSAGE ALERT
MODE=OFF
[
±]
To alert you with beeps when a new voice
message is recorded. If you hear slow beeps,
listen to recorded messages. The beeps will
stop.
“ON”: You will hear a beeping sound.
“OFF” (default): Deactivates this feature.
Code #43: Setting the recording time alert
REC. TIME ALERT
MODE=OFF
[
±]
To alert you with beeps when there is less than
60 seconds of remaining recording time. If you
hear slow beeps, erase the recorded messages
(page 52, 53). The beeps will stop.
“ON”: You will hear a beeping sound.
“OFF” (default): Deactivates this feature.
Code #44: Setting the memory reception alert
RECEIVE ALERT
MODE=ON
[
±]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
“ON” (default): You will hear a beeping sound.
“OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
MODE=ON
[
±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
“ON” (default): You do not have to press
{
FAX/START} for fax reception.
“OFF”: You have to press {FAX/START} for fax
reception.
Code #47: Setting the fax voice guidance
FAX GUIDANCE
MODE=ON
[
±]
If you wish to hear voice guidance for fax
transmission/reception, activate this feature.
“ON” (default): You will hear voice guidance.
“OFF”: Deactivates this feature.
“ERROR”: To hear voice guidance only when fax
transmission/reception fails.
Code #51: Setting the mailbox 1 password
BOX1 PASSWORD
ID=
To prevent other users from retrieving your
messages, program a password for mailbox 1.
1. Press {MENU}.
2. Press {#}, then {5}{1}.
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is “555”.
4. Press {SET}.
5. Press {MENU}.
Code #52: Setting the mailbox 2 password
BOX2 PASSWORD
ID=
To prevent other users from retrieving your
messages, program a password for mailbox 2.
1. Press {MENU}.
2. Press {#}, then {5}{2}.
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is “555”.
4. Press {SET}.
5. Press {MENU}.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
MODE=16s
[
±]
“16s” (default): Maximum recording time is 16
seconds.
“60s”: Maximum recording time is 60 seconds.
See page 51 for details.
Code #55: Greeting message for mailbox 1
BOX1 GREETING
CHECK
[
±]
See page 56 for details.
Code #56: Greeting message for mailbox 2
BOX2 GREETING
CHECK
[
±]
See page 56 for details.
Code #60: Setting the message transfer
MESSAGE TRANSFER
MODE=OFF
[
±]
FPG376.book Page 63 Wednesday, July 30, 2003 6:28 PM