Panasonic SL-PG4 - Manual (Page 9)

RQT5701
9
1.
3.
OPEN/CLOSE
1 2 3
4 5 6
7 8 9 0
≥10
SEARCH
A-B REPEAT REPEAT RANDOM AUTO
CUE
TAPE LENGTH SIDE A/B TIME FADE PEAK SEARCH
PROGRAM CLEAR RECALL TIME
MODE
SKIP
LEVEL
TAPE LENGTH SIDE A/B TAPE LENGTH PEAK SEARCH
SIDE A/B
1 9 0
PEAK SEARCH
TAPE LENGTH
1
2
-3.
3 2
-1.
POWER
CD edit recording
You can specify the length of the tape and the unit divides the tracks
on the CD between the two sides so they aren’t cut off.
A four-second interval is added between tracks so that tape program
sensor functions that find the beginnings of tracks will work correctly.
There is also a peak search feature that makes it easier to adjust the
recording level on the cassette deck.
Preparation: Prepare the cassette deck and tape.
Refer to the cassette deck’s operating instructions.
If it is a double-sided deck, set the reverse mode to single-sided re-
cording and the play direction to “
”.
1
Remote control only
Press [TAPE LENGTH] to specify the
tape length.
The tape length changes each time you press the button.
→ C-46 → C-60 → C-90 → C--- 
The unit programs the tracks to go on sides A and B.
•To select an irregular tape length, select “ C--- ”, then press
the numbered buttons to enter the total length of the tape (1
to 99 minutes). For example, for a five-minute tape, press [0]-
[5]. Press [TAPE LENGTH] to select “ C--- ” again if you
enter the wrong time.
•To add tracks to the extra space, see below.
•To show the information for side B, press [SIDE A/B].
2
Adjust the recording level.
1. Press [PEAK SEARCH].
The search takes about one and a half minutes for a 60-
minute CD. The unit repeatedly reproduces a 6-second seg-
ment around the peak.
2. Adjust the recording level.
Refer to the cassette deck’s operating instructions.
3. Press [ ] to stop the CD.
3
Press [ ] at the same time you begin
recording.
•When the tracks allotted to side A finish playing
Play pauses at the beginning of the first track for side B. Allow the
cassette deck to record to the end of side A.
•To continue recording on side B
1. Eject the tape and wind on the leader.
2. For a double-sided deck
Reinsert the tape and set the play direction to “ ”.
For a single-sided deck
Turn the tape over and reinsert it.
3. Press [ ] at the same time you begin recording.
To cancel CD edit mode
Press [ ].
For your reference
•You cannot edit more than 20 tracks.
To record in these cases, start normal play and recording at the
same time.
•You can record specific tracks by programming them first ( page
8, steps 1 and 2).
•Discs have multiple peaks so a different peak may be found each
time you perform a search.
Last track on side A Number of tracks on side A
Time remaining on side A
Track numbers on side A Track numbers on side B