Bosch PHA 2000 - Manual (Page 6)

4
Robert Bosch Hausgeräte GmbH
Please read through the instructions
carefully and proceed accordingly; store
in a safe place!
These instructions describe two models
with accessories.
Safety notes

!
Danger of electric shock and fire
Connect and operate the appliance only
according to the type plate specifications.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
Use only if power cord and appliance show
no signs of damage.
Unplug after every use or if defective.
Repairs to the appliance, such as replacing
a damaged power cord, may only be carried
out by our customer service in order to
avoid risks.
The power cord should not
– touch hot parts,
– be pulled over sharp edges,
– be used as a carrying handle.
The brushes will become hot.
Handle only the brush adapter end.
Do not use if hair is very wet. Do not use on
fake hair.
Do not use near water
contained in bathtubs, sinks,
or in other containers.

! Danger
Never allow the appliance to make contact
with water. Even a switched off appliance
poses a danger; unplug the appliance after
every use or when interrupted during use.
Installing a ground fault circuit breaker up
to 30 mA in the house offers additional
protection. Please consult an electrician.
Parts and accessories
PHA 200. (Figure
▄
A )
1 Temperature/blow switch 2 settings
2 Release button
3
Round brush with mixed bristles
PHA 230. (Figure
▄
B )
1 Temperature 2 settings
and cool setting
T
2 Release button
3
Round brush with mixed bristles
4 Brush Ø 30 retractable bristles
5 Concentrator brush
How to use
Never cover up the blower or intake. Make
sure that the intake is free from lint and
hair. The hot air styling brush will switch off
automatically if overheated due to an air
inlet that was covered. It will switch back on
automatically after a few minutes. Attach all
accessory parts at the
●
marking and twist
to ▼ to lock.
To change the accessory,
press the release button 2 and
take off the accessory part by
twisting.
en