Panasonic VQT0C55 - Manual (Page 56)

E-56
REMOTE menu
Ⅵ REMOTE menu
Items Setting Contents
LOCAL
FUNCTION
PREROLL
REM FF/REW
MODE
REM STOP SEL
PLAY DELAY
SYNCHRONI-
ZATION
CONTROLLER
SEL
NO KEY
EJECT
ⅷ STP + EJT
ALL KEYS
3SEC
5SEC
ⅷ 7SEC
10SE
ⅷ FF/REW
SEARCH
ⅷ EE
PB
ⅷ 0F
|
15F
OFF
ⅷ ON
TYPE1
TYPE2
ⅷ TYPE3
TYPE4
TYPE5
TYPE6
TYPE7
Use this to select the buttons on the main unit to be rendered operable
when remote controlling the unit via the 9 PIN REMOTE terminal:
NO KEY
: No button enabled.
EJECT : Only the EJECT button enabled.
STP + EJT : Only the STOP button and the EJECT button are ena-
bled.
ALL KEYS : All operation buttons are enabled.
When remote controlling the unit via the 9 PIN REMOTE terminal, use
this item to set the PREROLL time of the unit. Configurations done via
the editing remote controller prevail over other settings:
3SEC
: 3 seconds
5SEC : 5 seconds
7SEC : 7 seconds
10SEC : 10 seconds
Memo
To enhance editing precision, please set it to at least 7 seconds.
Use this menu item to set the action to be performed when an FF/REW
command is received via the 9 PIN REMOTE terminal or DV terminal:
FF/REW
: Sets the unit to execute FF/REW when a command is
received. This is the usual setting.
SEARCH : Sets the unit to go into the SEARCH state when a com-
mand is received. Use this setting if the locate(cue up)
function does not work well.
Use this menu item to set the action to be performed when a STANDBY
ON command is received via the 9 PIN REMOTE terminal or DV termi-
nal:
EE: Sets the unit to the EE mode. (The unit will go into the STOP mode.)
PB: Sets the unit to the PLAY mode. (The unit will go into the STILL
mode.)
Use this menu item to adjust the edit timing. When the remote control-
ler is used, there will be a slight delay time before edit starts. To rectify
the time discrepancy, adjust the timing for starting playback:
0F
: No compensation.
1F to 15F : Delay by the number of frames set by the user. When this
unit is connected to an editing remote controller with no
BUMP (synchronization) function, use this setting to ad-
just the editing precision.
Use this setting to turn on/off the BUMP function when the unit is con-
nected to an editing remote controller:
OFF : No synchronization.
ON
: Execute synchronization. The editing precision is enhanced .
Please set the pre-roll time to at least 7 seconds.
When remote control is executed via the RS-422A interface, use this
menu item to set the type of controller connected:
TYPE1
: Remote controller not of PANASONIC
TYPE2 : Remote controller not of PANASONIC
TYPE3 : AG-A850, AJ-A95
TYPE4 : Remote controller not of PANASONIC
TYPE5 - TYPE7 : (not in use)
MENU SCREEN – Contents of the menus –
(continued)