Appendix i - specifications, J6 specifications – Pride Mobility J6 2S User Manual
Page 40
40 www.pridemobility.com J6 Series
A P P E N D I X I - S P E C I F I C A T I O N S
J6 SPECIFICATIONS
Suspension:
Active-Trac Extreme (ATX)
Drive Wheels:
10 in. (25.4 cm), pneumatic and solid available
Front Caster Wheels:
5 in. (12.7 cm), solid
Rear Caster Wheels:
6 in. (15.24 cm), solid
Maximum Speed:
1
Up to 4 mph (6.44 km/h)
Range:
1,4
Up to 15 miles (24.14 km)
Brakes:
“Intelligent Braking” electromagnetic regenerative, disc park brake
Ground Clearance:
2
See figure 29.
Turning Radius:
2
See figure 29.
Overall Size:
2
Length:
See figure 29.
Width:
See figure 29.
Drivetrain:
Two motor, mid-wheel 6-drive
Batteries:
3
Two 12-volt, U-1 batteries
Battery Charger:
5-amp, off-board
Weight Capacity:
300 lbs. (136 kg)
160 lbs. (72.57 kg) with Synergy Manual Tilt
250 lbs. (113.4 kg) with Synergy TRU-Balance Power Positioning Systems
Component Weights:
2,5
Base: 104.5 lbs. (47.4 kg) without seat and batteries
Contour Seat: 42.5 lbs. (19.28 kg)
Batteries: 24.5 lbs. (11.11 kg) each
Freewheel
Operational Force
Left: 54 N Right: 54 N
1
Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery condition, motors, controller
type, tire type, and tire condition.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to a variance of (+ or – ) 3%.
3
AGM or Gel-Cell type required. See VI. “Batteries and Charging.”
4
Tested in accordance with ANSI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculation
based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
5
Battery weight may vary based on battery manufacturer.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176 series EN12184
standards. All specifications subject to change without notice.