Pico Communications PICOPSU-90 - Manual (Page 2)

Mini-Box.com ATX DC-DC Converter Series
picoPSU-90 Quick Installation Guide Page 2
PicoPSu-90 shown with the D201GLY Intel Motherboard.
2) Connect a 12 VDC power adapter (or any 12V source) to the DC-to-DC
connector, center pin / white wire is positive (+).
3) Turn on the PC using the motherboard ON/OFF motherboard switch
Typical configuration
The picoPSU-90 has been tested with all mini-ITX board (VIA C3, VIA C7, low
power AMD and Atom) under virtually any disk / floppy / CDROM / PCI
configuration. Additionally, the PICOPSU-90 can power low boards equipped
with an 12VATX 4 pin connector. NOTE: The hard drive cable harness can be
disconnected in case the user does not need any peripheral. Additionally, the
cable harness can be made to any length or output connector type provided that
the max load does not exceed 3A for GND return. Please look under
specifications for the mating connector type.
Removing the picoPSU-90
In order to remove the picoPSU you must release the power connector latch and
then remove the unit. Gently lift the picoPSU out from the ATX connector, by
grabbing from the picoPSU PCB, not from components or the wire harness.