Gaining access to the system, Access through the serial port – Patton electronic 1052 User Manual
Page 43
Gaining Access to the System
43
OnSite Series Getting Started Guide
4 • System Management Access
Gaining Access to the System
There are two ways of gaining access to the system management functions. One way is through the SERIAL
port and the command line interface (CLI). The other way is through the Ethernet LAN port and the web
browser interface. The following sections describe the procedures for each of the access methods.
Access through the Serial Port
To gain management access to the system for the first time through the SERIAL port, follow these steps:
1. Connect a PC to the SERIAL management port.
Note
Use the DB-9-to-RJ-45 adapter cable supplied with the system.
2. Launch the VT100 terminal emulation program on the PC.
Note
Configure the terminal in accordance with the settings in Table 14.
3. Press the Enter key on the PC to obtain a login prompt from the system.
4. Log in to the system using the Super user ID and password.
Note
Only the Super user is able to perform the following task.
Note
The user ID for the Super user is super (all lowercase letters).
Note
The factory-assigned default password for the Super user is super (all
lowercase letters).
After successful completion of the login, the system responds with the CLI (command-line interface)
prompt.
Note
The CLI command prompt for the system is OnSite >
5. Type the following CLI command to configure the IP address for the Ethernet LAN management port,
and then press the Enter key:
config mgmt-enet ip-address aaa.bbb.ccc.ddd
Note
aaa.bbb.ccc.ddd is the standard dotted-decimal notation.
6. Type the following CLI command to configure the net mask for the Ethernet LAN management port, and
then press the Enter key:
config mgmt-enet ip-netmask aaa.bbb.ccc.ddd
7. Type the following CLI command to configure the default gateway for the Ethernet LANmanagement
port, and then press the Enter key:
config mgmt-enet default-gateway aaa.bbb.ccc.ddd
Note
By default, the IP address is set to 192.168.2.100, the net mask is set
to 255.255.255.0, and the default gateway is set to 192.168.2.1