Panasonic M282737F - Manual (Page 11)

Assembly (continued)
11
Step Four: Attach wheels to cart base
1. Slide axle into holes on bottom of cart.
2. Slide tires and wheel retainers onto the axle.
3. Tighten wheel retainers with supplied hex wrench.
Step Five: Attach pressure gauge
1. Remove and discard the plug in the gauge port.
2. Thread in gauge. Hand tighten.
Step Six: Attach gun hose to spray gun and pump
1. Install hose clamps on hose. Follow hose clamp installation instructions below.
2. Using 2 hose clamps, attach one end of the gun hose to the pump hose barb.
3. Using 2 hose clamps, attach the other end of the gun hose to the spray gun.
02622
Plug
Pressure gauge
Gun hose
Hose clamps
Spray gun
Hose clamps
Hose Clamp Instructions:
i) Slide hose clamp over
the end of the hose.
ii) Push the hose onto the
hose barb.
iii) Slide the hose clamp
over the hose barb.
iv) Tighten the hose clamp
Wood plank
or spacer
(Not included)
Cart base
Axle
Tire
Wheel
retainer