Plantronics CS60 - Manual (Page 12)

11
MUTE YOUR VOICE
The mute feature, when activated, allows you to hear the person you are calling, but
they cannot hear you. To mute a call press and release the Volume/Mute control (4).
When mute is enabled, the headset sounds two short tones every 15 seconds. In addi-
tion, the Status indicator (12) will flash rapidly. To de-activate mute, press and release
the Volume/Mute control (4) again.
3. AUDIBLE WARNINGS
The headset provides status information and signals a warning by sounding beeps as
described below:
OUT OF RANGE WARNING
As you walk away from the base unit you will eventually reach the system operating
range limit. When in use, a warning alert of two beeps will sound in the headset short-
ly before you meet the range limit. On hearing this alert you should walk closer to the
base unit to ensure call quality is maintained. If you ignore this alert and walk out of
range, a triple beep will sound in the headset and any active call will be suspended.
On returning within range, a single beep will sound and the call will be re-established.
If you remain out of range for more than 15 minutes the system will drop the call per-
manently. If using a compatible softphone the call will be terminated.
MUTE WARNING
If the mute button has been pressed, a double beep will sound every 15 seconds. This
will continue to sound until the call is terminated, or the mute button is pressed again.
LOW BATTERY WARNING
When the headset battery is running low (approximately 5 minutes talk time remain-
ing), an audible warning will be heard through the headset as a single beep repeating
every 10 seconds. Soon after hearing this warning, you should recharge the headset.
HEADSET NOT PAIRED WITH THE BASE
If a headset is not correctly subscribed to a base unit, a warning alert of three beeps
will sound when the talk button is pressed, and no link will be made between the
headset and the base unit. This beep will continue to be heard when the button is
pressed until the headset is subscribed to the base unit. To do this, follow the proce-
dure in section 7.