Pioneer DVD AV RECEIVER AVH-P3100DVD - Manual (Page 91)

Adjusting 3-band parametric equalizer
For Custom1 and Custom2 equalizer curves,
you can adjust the front, rear and center
equalizer curves separately by selecting a cen-
ter frequency, an equalizer level and a Q factor
for each band.
! A separate Custom1 curve can be created
for each source.
! A Custom2 curve can be created common
to all sources.
! The center speaker largely determines the
sound image and getting the balance right
isn
’t easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Touch Parametric EQ.
2 Touch a or b to select the desired item.
Each time you touch a or b selects the item
in the following order:
Equalizer (equalizer)
—SP-Select (speakers)—
Band (bands)
—Frequency (center frequency)
—Level (equalizer level)—Q. Factor (Q factor)
3 Touch d to select the equalizer.
Touch d repeatedly to switch between the fol-
lowing equalizers:
Powerful
—Natural—Vocal—Flat—Custom1
—Custom2—Super Bass
4 Touch b and then touch c or d to se-
lect the speaker to be adjusted.
Touch c or d until the desired speaker ap-
pears in the display.
Rear (rear speakers)
—Center (center speaker)
—Front (front speakers)
# You cannot select speakers whose size is set
to
Off. (Refer to Setting the speaker setting on
page 87.)
5 Touch b and then touch c or d to se-
lect the equalizer band to be adjusted.
Each time you touch c or d selects equalizer
bands in the following order:
Low (low)
—Mid (mid)—High (high)
6 Touch b and then touch c or d to se-
lect the center frequency of selected band.
Touch c or d until the desired frequency ap-
pears in the display.
40Hz
—50Hz—63Hz—80Hz—100Hz—125Hz
—160Hz—200Hz—250Hz—315Hz—400Hz
—500Hz—630Hz—800Hz—1kHz—1.25kHz
—1.6kHz—2kHz—2.5kHz—3.15kHz—4kHz
—5kHz—6.3kHz—8kHz—10kHz—12.5kHz
7 Touch b and then touch c or d to ad-
just the equalizer level.
Each time you touch c or d it increases or de-
creases the equalizer level.
+12 to -12 is dis-
played as the level is increased or decreased.
8 Touch b and then touch c or d to se-
lect the desired Q factor.
Each time you touch c or d switches between
the following Q factor:
Narrow (narrow)
—Wide (wide)
# You can adjust parameters for each band of
the other speakers in the same way.
Note
You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.
Available accessories
En
91
Section
19
A
vailable
accessories