PYLE Audio View Series PLVWAN6 User Manual

Page 2

Advertising
background image

Wiring the Antenna

Caution while lnstalling the Antenna

Prior to the final installation, temporarily connect the
wires to make sure that all connections are made properly
and to make sure that the system works properly.

Install the 4 antenna plugs into the TV tuner and the
Cigarette light plug into the lighter outlet.

Note: The cigarette lighter plug may be removed and the
red power wire may be connected to a 12 volt switched
power source by using a 5 amp fuse (not provided) Check
with a meter to be certain that the +12 volt power is
switched or battery drain will occur. The black wire should
have a #6 ring terminal crimped on (not supplied) and
connected to chassis ground.

Install the antenna onto the inside glass so it does not fall
down while driving.

Install on a clean glass surface. Moistrue can cause the
antenna to fall down.

Low temperature decreases the adhesion. Therefore, turn
on the heater if temperature is below 68 degree Fahrenheit.
Do not touch the sticky part of the tape.

Keep the distance between the side of window and antenna
element to a minimum of 1 inch. Touching the windows
can affect the teansmission.
Do not run the antenna cables next to power or speaker
leads or noise problems can occur.

Installing the Antenna

Antenna Performance

Thoroughly clean the glass area with a clean cloth and glass
cleaner.

Be certain temperature of the glass is above 68 degrees Fahrenheit.

Remove the protective tape and mount the booster section.

Remove the protective tape and mount the antenna wire sections.

Make certain that antennas are securely installed with antenna
holders provided.

Stick the protective seal on the outside of the window to hide the
sticky part of the booster amp.

A car with a rear defroster or heating refract film can deflect the
signal which causes poor reception.Please check the type of glass
and film before installing the product.

Install this product on the inside of the car. Therefore, in some
cases,image of television can be affected.

Weak signals can be the cause of poor image or sound.

Heater, fan and other functions of the car can affect the TV
reception.

Tunnels or building can deflect the signals.

Specification

TV ANTENNA

POWER : DC 12-14.4V

AUX TYPE : MINUS

MAX POWER AMP : 50mA

OUTPUT TERMINAL : 3.5 MINI PLUG *2(1PCS)

LENGTH OF THE ANTENNA CABLE : 16.54 INCHES

SIZE OF THE BOOSTER AMP SECTION : 2.56*2.13INCHES

WEIGHT : 470G(INCLUDING CABLE)(1PCS)

POWER : DC 12-14.4V

AUX TYPE : MINUS

MAX POWER AMP : 50mA

OUTPUT TERMINAL : 3.5 MINI PLUG *2(1PCS)

LENGTH OF THE ANTENNA CABLE : 16.54 INCHES

SIZE OF THE BOOSTER AMP SECTION : 2.56*2.13INCHES

WEIGHT : 470G(INCLUDING CABLE)(1PCS)

ACCESSORY

POWER CORD HOLDER : 6

ANTENNA HOLDER : 4

BODY COVER : 2

INSTRUCTION BOOK :1

POWER CORD HOLDER : 6

ANTENNA HOLDER : 4

BODY COVER : 2

INSTRUCTION BOOK :1

Note :

Parts or design are subject to change without notice.

16.54in.

2.56in.

2.13in.

(Fig 3)

Advertising