6 programming the ipod2car, Dip switch confi guration chart, Top view – Peripheral Electronics iPod2car User Manual
Page 12: Fig.1 side view of interface with dip switches
TOP VIEW
1 2 3 4 5 6 7 8
DIP
ON
DIN CONNECTOR / DIP SWITCH VIEW
22-PIN HARNESS VIEW
1.6 Programming the iPod2car
Now that you have identifi ed the correct harness and dip-switch confi guration us-
ing the application guide, it is now time to program the interface.
To program the interface, set the dip-switches located on the side of the interface
(see Fig.1 below) to the congfi guration listed for your vehicle in the Application
guide. Switches are in their default setting of “off” in the up position and are turned
“on” when switched down. Refer to the chart on the bottom of this page.
This programs the iPod2car to the vehicle it is being installed in. The dip-switch-
es MUST be set before the interface is plugged into the vehicle. Otherwise the
iPod2car will not work correctly.
Dip Switch Confi guration Chart
Fig.1 Side view of Interface with dip switches
1
2
3
4
5
6
7
8
Confi g. #1
ON
off
off
ON
off
off
off
ON
Confi g. #2
ON
off
off
off
off
off
off
ON
Confi g. #3
off
off
off
ON
off
off
off
ON
Confi g. #4
off
ON
off
off
off
off
off
ON
Confi g. #5
ON
ON
off
off
off
off
off
ON
Confi g. #6
off
off
ON
off
off
off
off
ON
Confi g. #7
ON
off
ON
off
off
off
off
ON
Confi g. #8
off
ON
ON
off
off
off
off
ON
Confi g. #9
ON
ON
off
ON
off
off
off
ON
10