Panasonic KX TG2258PW - Manual (Page 54)

54
Troubleshooting
Cordless Telephone
Problem Cause & Remedy
“ No link to base. Place
on cradle and try
again. ” is displayed and an
alarm tone sounds.
• You are too far from the base unit. Walk
closer and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
Static, sound cuts in/out,
fades. Interference from other
electrical units. • Move the handset and the base unit away
from other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 23,38).
The handset and/or base unit
does not ring. • The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 17).
• When the handset is on the base unit, the
handset does not ring. Only the base unit
rings when receiving a call.
The handset display is blank. • Charge the battery fully (p. 8).
You cannot program function
items. • Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
While programming or
searching, the unit starts to
ring and stops the program/
search. • A call is coming in. To answer the call, press
[ ] , [ ] or [SP-PHONE] . Start again from
the beginning after hanging up.
You cannot make a call with
the handset. • Your handset is in remote operation mode
(p. 44). Exit by pressing [OFF] .
You cannot redial. • If the last number dialed was more than
32 digits long, the number will not be redialed
correctly.