Panasonic AG-HPX172EN - Manual (Page 58)

58
Recharging the built-in battery
The camera’s internal battery saves the date and
time. “
” appears on the screen of the viewfinder
or LCD when the internal battery is running low on
charge.
Do the following to recharge it.
Reset the date and time when fully recharged.
1
Connect the AC adapter. (Page 15)
Leave the POWER switch at OFF.

Leave the camera-recorder like this for
about  hours.
The internal battery charges during this time.
Recharge the battery regularly to ensure
correct TC and menu operations.
If “ ” appears even after charging, it means that
the internal battery must be replaced. Ask your
dealer to do this.
Setting the time code
In the setup menus, RECORDING SETUP
screen, set the following time code related items.
(Page 104)
TCG
TC PRESET
19 TC REGEN (appears when in MCR mode)
In MCR mode and 1394 TC REGEN is ON, you
cannot change the items shown above.
•
•
•
•
•
•
Specifying the time code (TC PRESET)
Set TC PRESET so you can record a value of your
choice as the initial setting for the time code to be
used at the start of recording.
1
Set the POWER switch to ON.

On the setting menu RECORDING SETUP
screen, push the Operation lever in the e
or r direction to move to TC PRESET and
press it again.
RECORDING SETUP
PUSH MENU TO RETURN
MIC GAIN2 -50dB
2CH
DF
REC RUN
––––
FRM.RATE
––––
OFF
25M REC CH SEL
UB MODE
UB PRESET
TC MODE
TCG
TC PRESET
TIME STAMP

Push the Operation lever in the r direction
to move to YES and press it again.
RECORDING SETUP
PUSH MENU TO RETURN
MIC GAIN2 -50dB
2CH
DF
REC RUN
––––
YES
––––
OFF
25M REC CH SEL
UB MODE
UB PRESET
TC MODE
TCG
TC PRESET
TIME STAMP

When the screen below appears, set the
time code value.
Push the Operation lever in the e or r
direction to select a time code value.
TC PRESET
PUSH MENU TO RETURN
MONTH
+/– : PUSH q / g
0 0 h 0 0 m 0 0 s 0 0 f
SEL : PUSH t / y
Charging the built-in battery/Setting the time data