Philex SLxB - Manual (Page 3)

SET UP 3:
Satellite Receiver Signal Distribution
1. Connect your UHF aerial downlead into the
VCR’s UHF aerial input. If you do not have a
VCR, plug the UHF aerial downlead into the
satellite receiver’s UHF aerial input and ignore
all further references to VCRs.
2. Connect the VCR RF output lead to the aerial
input on the satellite receiver.
3. Connect the satellite receiver via the Scart
outputs to the VCR and TV.
4. Connect an output lead from the satellite
receiver RF1 output to the aerial input on
your main TV.
SET UP 3
TV/ VCR/SAT/FM
DISTRIBUTION
Main
TV
TV 2
Additional TV sets / Hi-Fi
Scart
connection
Video
Recorder
Satellite
Receiver
RF2 out
RF1 out
Satellite
output lead
Aerial
downlead
Aerial flylead
Link
Aerial
flylead
FM (Radio)
and/or
VHF TV on
EIR modems
Aerial
downlead
UHF (TV) Satellite
5. Connect an output lead from the satellite receiver
RF2 output to your aerial amplifier IN UHF socket.
UHF TV, VCR playback and satellite receiver signals
will now be available to your main TV and to any TV
you now connect to the amplifier TV sockets. For FM
connection see SET UP 1.
To operate your digital satellite receiver from one of
the connected TVs you will now need to install a
Link device such as the SLx Link.
N.B. It may be necessary to retune the output
channel of your VCR when used with a satellite
receiver. Consult your VCR user guide.