Pacific Cycle CUCINA HR7633 - Manual (Page 11)

14 13
Tightening/Preloading Aheadset
Stem Installation
(Should be assembled on the bike already)
1. Insert the compression bolt through the top
cap and the stem. Begin threading into the
star nut.
2.Tighten compression bolt so it removes all
play from the fork, but allows the fork to rotate
smoothly.
3. Align the stem with the front wheel. Tighten
the stem clamp bolts to secure the stem to the
steerer tube.
Handlebar Installation
1. Remove the stem cap bolts and stem cap.
2. Insert handlebar into the stem cap.
3. Tighten the stem cap bolts equally. Note
the distance between the stem and stem cap:
It should be equal on the top and bottom of the
stem cap.
A must be equal distance.
Installed
by
factory
Compression Bolt
Top Cap
Stem Clamp Bolts
Spacer
Headset Wedge
Bearing Race
Bearing Dust Cover
Bearing Retainer
Star Nut
(Inside Steerer Tube)
Upper Headset Cup
Headtube
Lower Headset Cup
Bearing Retainer
Bearing Dust Cover
Headset Crown Race
fork
Steerer
T
ube
Handlebar
Stem Cap
Bolts
Stem Cap
Stingray Scooter Front
Fender Assembly
After the first fork leg is installed:
1. Assemble front fender to fork leg and hand
tighten bolt. When installing second fork leg,
remove fender mounting bolt first, assemble
fork leg, and re-install fender mounting bolt.
Hand tighten.
At the end of fork assembly:
2. After fork and front wheel are completely
assembled, center fender and tighten both
mounting bolts securely.
Step #3
Using 5mm hex (Allen) wrench, tighten the two
lower fork crown pinch bolts completely. Please
note that these bolts should be tightened until the
fork is secure only, DO NOT OVER TIGHTEN,
or damage to the lower fork crown may occur.
1. 2.