Profoto D1 250 - Manual (Page 14)

Profoto D1
14
www.profoto.com
Modeling light setting
1. Use the Model Button [10a] to select the modeling light:
a. To select proportional modeling light, press and hold down the Model Button [10a]
until the PROP Indicator [10b] is illuminated.
b. To select free modeling light, press and hold down the Model Button [10a] until
the FREE Indicator [10c] is illuminated. The energy level of the latest selected free
modeling light setting will be activated.
c. To turn off the modeling light, press the Model Button [10a]. Both the PROP
Indicator [10b] and the FREE Indicator [10c] will be turned off. Press the Model
Button [10a] again to turn on the modeling light.
Change the level of the free modeling light:
1. Verify that free modeling light setting is selected (the FREE Indicator [10c] shall be
illuminated when the modeling light is turned on).
2. Press the Model Set Button [11]. The Display [1] will start flashing, showing the current
energy level of the Free modeling light.
3. While the Display [1] is flashing, use the Setting Knob [7] to change the energy level:
a. Turn the Setting Knob [7] clockwise to increase the energy level in 1/10 f-stop
increments and counter-clockwise to decrease.
b. Press and hold down the Setting Knob [7] and turn the knob clockwise to increase
the energy in 1 f-stop increments and counter-clockwise to decrease.
4. Wait until the Display [1] stops flashing. (The Display [1] will now show the energy level
of the flash light.)
ready signaling setting
1. Use the Ready Button [9a] to select the ready signaling:
a. To select sound signaling, press and hold down the Ready Button [9a] until the
BEEP Indicator [9b] is illuminated.
b. To select light signaling, press and hold down the Ready Button [9a] until the DIM
Indicator [9c] is illuminated.
c. To select both sound and light signaling, press and hold down the Ready
Button [9a] until both the BEEP Indicator [9b] and the DIM Indicator [9c] are
illuminated.
d. To turn off the ready signaling, press the Ready Button [9a]. Both the BEEP
Indicator [9b] and the DIM Indicator [9c] will be turned off. Press the Ready
Button [9a] again to turn on the ready signaling.