Polk Audio DR-3 - Manual (Page 13)

www.polkaudio.com 13
Macro Sequence Programming Example:
Confused? Don’t worry, it isn’t as bad as it looks. Let’s walk you
through a hypothetical Macro sequence to show you how it works.
In this example, we are programming the DVD source Macro button
to turn on the TV, the Digital Solution system and the DVD player as
well as select the DVD player as the source to view. In this case,
we are assuming that you have programmed the TV codes into the
CBL Source/Device.
1. Press and hold the CODE button for two seconds. The status light at
the top left of the remote will glow red.
2. Press the DVD Source button. The DVD Source button will light up.
3. Press the MACRO button. The red status light and the DVD button
lights will blink once.
4. Press the CBL Source button
5. Press the SOURCE POWER button to select the TV’s
power command.
6. Press the SYSTEM POWER button to select the Digital Solution’s
power command.
7. Press the DVD source button.
8. Press the SOURCE POWER button to select the DVD’s
power command
9. Press and hold the SAVE button until the red status light and the
Source button lights will blink twice and then turn off to confirm
the program.
In this example the sequence is important. The DVD turn-on command
should be the last command in the Macro string, so that the Digital
Solution system’s input is on.
Factory Reset
If you want to restore the DR-3 to it’s original programming and
operation, press the LIGHT and POWER buttons simultaneously
for 10 seconds. The red status light will blink while the remote is
resetting. It will confirm the reset by blinking green and then orange.
MACRO OPERATION
1
5,8
2,7
6
3
9
4