Photogenic Professional Lighting CFF4 - Manual (Page 3)

1.
Before installing or removing the flashtubes and modeling lamps, be sure this
appliance is turned off, cooled and unplugged from AC power source and
external power supply.
2. Do not operate this appliance with a frayed or damaged cable
3. Do not attempt to use this appliance if it has been dropped or damaged, until a
qualified service person has serviced it.
4. Do not operate the unit with a damaged or broken flashtube or modeling lamp.
Do not use flashtubes with broken, cracked or missing glass envelopes. To
prevent damage always use Photogenic specified replacements for the
flashtubes and modeling lamps.
5. Perform no internal service work on this unit. Refer all such service to a
qualified service person or return to the factory. This will provide you safety
and continuation of your warranty.
6. Do not operate when water is present and from extreme temperature shifts. If
the unit is stored in hot or below freezing temperatures, allow at least one hour
at room temperatures before using.
PREPARATION AND BASICS
Unpacking and Setup:
Unpack all units carefully to remove all parts from the carton(s). Do not discard or
destroy the packing material until the equipment has been inspected, assembled,
and all parts accounted for.
After unpacking, all parts should be examined for any damage, which may have
been caused by rough handling during shipment. If any damage is detected,
contact the delivering carrier at once. Claim for damage should be made to the
delivering carrier before destroying packing cartons.
Unpacking and Setup:
The unit is shipped with the modeling lamps and flashtubes not installed. While
installing the modeling lamps and flashtubes (with glove or clean cloth to protect
the hand) be sure they are properly inserted and tight to avoid arcing and failure of
the socket contacts during operation. Always use a clean cloth or wear gloves to
protect your hand from glass breakage and heat. Place the unit on a stable flat
surface, face up.
The diffusion panel is held in place with an “L” bracket and thumbscrews. Remove
the thumbscrews and “L” bracket. Slide out the diffuser panel. The paper
protective sheet must be peeled off the diffusion panel. Use finger nails to start
peeling at two corners and continue carefully peeling protective sheet until it is all
removed. Do not use razor blade or other mechanical scrapers.
The fluorescent lamps have no polarity. Remove any plastic film from reflector.
Install by inserting the glass body into the clear support bracket, and then insert the
pins into the top of the socket holes and press base down to snap pins into contacts.