Connecting cables on the rmx 1500, First-time power-up – Polycom DOC2557A User Manual
Page 12
Chapter 1-Hardware Description
1-8
Connecting Cables on the RMX 1500
To connect the cables:
•
For the RTM-IP 1500 module:
—
Connect the Media cable to LAN 2 port.
—
Connect the Network cables to the MNG (Signaling) port &
MNGB (Management Network) port.
—
(Optional) Connect the Shelf Management cable to the Shelf port.
•
For the RTM ISDN 1500 module:
—
Connect the E1/T1 cables to their PRI (1-4) ports.
Figure 1-1
RMX 1500 Rear Panel View with AC Power and Communication
Cables
First-time Power-up
1
For first entry installation, you must insert the USB key containing the
modified IP addresses in USB slot on the RMX’s front panel. For more
information see, the RMX 1500/2000/4000 Getting Started Guide,
"Procedure 1: First-time Power-up” on page
2-19
.
2
Turn ON the power by pressing on the power switch located on the
front panel of the RMX 1500.
E1/T1 PRI
Connection(s)
Power Cable
LAN 2; media, MNG; signaling,
MNGB; management & Shelf
The LAN 1, LAN3, LAN4 and Modem ports are not be used and the plastic caps
covering those ports should not be removed.