Pride Mobility JET2 - Manual (Page 24)

24 www.pridemobility.com Jet 2/Rev F/Feb03
V I . C O M F O R T A D J U S T M E N T S
Figure 16. Footrest Height
REMOVE THIS NUT AND BOLT
TO CHANGE FOOTREST HEIGHT.
Figure 17. Footrest Angle
TURN SETSCREW TO
CHANGE FOOTREST ANGLE.
FOOTREST HEIGHT
The footrest height is easily adjusted to one of six different
heights in one-inch increments.
To raise or lower the footrest:
1. Use a 5/16-in. hex key and a 7/16-in. wrench to re-
move the nut and bolt as shown in figure 16.
2. Raise or lower the footrest to the desired height.
3. Reinstall the nut and bolt into the footrest and tighten.
FOOTREST ANGLE
You can adjust the angle of the footrest with a 7/32-in. hex
key. See figure 17.
To adjust the footrest angle:
1. Loosen the jam nut.
2. Turn the setscrew clockwise to lower the front of the
footrest.
3. Turn the setscrew counterclockwise to raise the front of
the footrest.
4. Tighten the jam nut.
SWING-AWAY FOOTRESTS OPTION
Swing-away footrests (SFRs) are an option. They enable
you to move the leg rest to the side before getting off your
Jet 2.
To move the SFRs:
1. Push in the SFR release lever. See figure 18.
2. Move the SFRs aside.
ELEVATING LEG RESTS OPTION
Elevating leg rests (ELRs) offer an infinite range of adjust-
ment for the leg angle and a footrest adjustment range of
12-19 in.
To adjust the ELR angle:
1. Press the release lever. See figure 19.
2. Move the leg rest to the desired angle.
SFR RELEASE
LEVER
Figure 18. Swing-away Footrests