Planet Technology WAP-4030 - Manual (Page 11)

7
Parameters Description
Service Set ID (SSID) The SSID (up to 32 printable ASCII characters) is the unique name identified in a
WLAN. The ID prevents the unintentional merging of two co-located WLANs.
Please make sure that the SSID of all stations in the same WLAN network are
the same.
Broadcast SSID in the
Beacon
When enabled, WAP-4030 will broadcast its SSID to the wireless network. To
keep your WLAN more private, it is suggested to uncheck this option.
Radio Preamble Preamble type defines the length of CRC block in the frames during the wireless
communication.
Auto select: It will auto switch to the more suitable method.
Short: It is suitable for high traffic wireless network
Long: It can provide more reliable communication
AP Mode It allows user to select Mixed mode, G only mode or B only mode. If “Mixed
mode” is selected, please configure the rate selections below to “Auto”.
Rate selection for B When the AP is configured in “B only mode”, you can select the desired data rate
here.
Rate selection for G When the AP is configured in “G only mode”, you can select the desired data rate
here.
RF Channel The value of RF Channel can be selected from channel 1 to 11 for FCC domain,
channels 1 to 13 for ETSI domain and 1 to 14 for Japan domain.
RTS Threshold
(256-2432)
Use this field to specify a value for the RTS Threshold. Enter a value between
256 and 2432. This value should remain at its default setting. Should you
encounter inconsistent data flow, only minor modifications are recommended.
Beacon Period
(20-1000)
Specify the Beacon Period value. Enter a value between 20 and 1000. Beacons
are packets sent by an Access Point to synchronize a wireless network.
DTIM Period
(1-255)
Enter a value between 1 and 255 that specifies the Delivery Traffic Indication
Message (DTIM). A DTIM is a countdown informing clients of the next window for
listening to broadcast and multicast messages. When the AP has buffered
broadcast or multicast messages for associated clients, it sends the next DTIM
with a DTIM Interval value. AP Clients hear the beacons and awaken to receive
the broadcast and multicast messages.
3.3 Security
This Access Point provides the wireless LAN security functions, including 64/128-bit WEP, and
WPA-PSK. With these security functions, you can prevent your wireless LAN from illegal access.