PYLE Audio PDWM96 - Manual

�"3>PYLE® PDWM96
PR()
WIRELESS CLIP-ON MINI. MICROPHONE
OPERATING INSTRUCTION
It is very happy that you have this professional Wireless Clip-on Mini. Microphone of
good quality which will bring you convenience when you are using it in the situation of
teaching,conference,monitoring etc.
HOW DO YOU OPERATE IT?
l.Open the bottom cover (4) of the transmitter, insert the battery with the correct
polarity and close the bottom cover until it clicks shut.
2.Insert the Mic. connector(9) into the socket(1) of transmitter.
3.0pen the battery cover (5) of the receiver, insert two batteries (size
AAA) into the
receiver with correct polarity and close the battery cover.
4.Plug the receiver into the input socket for microphone of amplifier, set both switch(2)
of transmitter and switch(8) of receiver to ON position, then the pilot lamps (3) and
(7) are on that indicates a good condition and it is ready for operation.
ATTENTIONS
1.If acoustic quality and volume are abnormal or receiving
batteries in transmitter and receiver should be . replaced,
normal operation,you can carefully trim the frequency by
receiver with a screwdriver to become normal operation.
distance is shortened,the
if thereafter still not in
adjusting the screw(6)in
2.If your micropbone isn't used for a long period, the battery should be taken out to
avoid its deterioration and the damage of components.
3.If two wireless microphones are used at the same time, you should use them with
one red and another green lamp and can't use them with the lamp of the same color.
4.If the microphone is too close to the speaker or the volume of the amplifier is too
loud,shrill sound will occur and that may damage the amplifier or speaker.in that
case, please keep microphone long distance from the speaker and turn down the
volume of amplifier.
SPECIFICATIONS
I.Modulation ........
.
............................... .......... FM
2.Frequency response .......................... .......... 80 to 12500 Hz
3.0utput impedance ........................................ 600 ohm
4.0perating voltage .................................... ... 9V DC for transmitter
3V DC for receiver
5.Effective distance ........................................ 20 m
www.pyleaudio.com