Planet Technology GSW-2416 - Manual (Page 16)

15
2.2.2 Rack Mounting
To install the Gigabit Ethernet Switch in a 19-inch standard rack, follow
the instructions described below.
Step 1: Place your Gigabit Ethernet Switch on a hard flat surface,
with the front panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the Switch with
supplied screws attached to the package. Figure 2-6 shows
how to attach brackets to one side of the Gigabit Ethernet
Switch.
Figure 2-6 Attaching the brackets to the Gigabit Ethernet Switch
Caution:
You must use the screws supplied with the mounting brackets. Damage
caused to the parts by using incorrect screws would invalidate your
warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the
opposite side.
Step 5: After the brackets are attached to the Gigabit Ethernet
Switch, use suitable screws to securely attach the brackets to
the rack, as shown in Figure 2-7.