PNY P-DSA2-PCIE-RF - Manual (Page 5)

J4,J3, J2, J1 Internal SATA Port C
enabled (Con4)
J4,J3, J2, J1 External SATA Port A
enabled (Con1)
NOTE
There are four SATA ports on the card.
However only two of the four ports may
be enabled at any time.
Hardware Installation
Aug/07 MN2036400001 5
1. Turn Off the power to your computer and all the connected
peripheral devices.
2. Unplug the power cord from the back of the computer.
3. Remove your computer’s cover.
4. Remove the slot bracket from an available PCI Express slot.
5. To install the card, carefully align the card’s bus connector with
the selected PCI Express slot on the motherboard. Push the board
down firmly, but gently, until it is well seated.
6. Replace the slot bracket’s holding screw to secure the card.