Planet Technology WAP-4030A - Manual (Page 8)

Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WAP-4030A.
2.1 Hardware Connection
12V DC
LAN
RESET ANT
+
1. Locate an optimum location for the WAP-4030A. The best place for your WAP-4030A is
usually at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antenna to WAP-4030A. Try to place them to a position that can best cover your
wireless network. The antenna’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WAP-4030A. Connect this WAP-4030A to your LAN switch/hub or a
single PC.
4. Plug in power adapter and connect to power source. After power on, WAP-4030A will start to
work.
Note: ONLY use the power adapter supplied with the WAP-4030A. Otherwise, the product may be
damaged.
If you want to reset your WAP-4030A to default settings, press the Reset button 5 second.
Then release the button and wait for 10 seconds for rebooting.
8