Pella V983492 - Manual (Page 4)

Page-4
G. Apply sill flashing tape #2. Cut a piece of flashing tape
12" longer than the opening width. Apply at the bottom,
overlapping tape #1 by at least 1". DO NOT allow the tape to
extend past the interior face of the framing (1G).
Note: The flashing tape does not need to extend all the way
to the interior of the framing.
1"
1G
TWO OR MORE PEOPLE WILL BE REQUIRED TO hANDLE ThE PANEL SAfELY
A. Remove the packaging from the door. Inspect
the frame and panels for damage. DO NOT install
damaged units.
Note: If screens or hardware are removed from
the door at this time, label them and store them in
a protected area.
B. Locate the kitted parts bag. Remove from unit and
place in a safe location that is accessible during the
door installation.
C. Remove the vent panel. With the jamb side of the
door down, slide the panel all the way to one direction,
while lifting the panel out of the bottom frame pocket.
Swing the panel out of the frame.
D. Transom/Sidelight only: Remove the sill track and
pocket covers by pulling on the paper ring. DO NOT
damage these items as they will be re-installed once
the frame is fastened to the opening.
Interior View
1
2
2B
If using optional sill pan, see Step 10 Sill Pan fabrication and Installation on page 15.
TWO OR MORE PEOPLE WILL BE REQUIRED TO hANDLE ThE PANEL SAfELY
A. To remove the bottom fin, lay the door down with the interior facing up. With a utility
knife, carefully score the entire length of the fin three times where it meets the sill. Bend the
fin back and forth a few times, then peel the fin off.
Note: Keep the body of the knife against the frame to prevent gouging the sill.
If installing in a block replacement or a concrete floor, go to Step 3A to remove the bottom
fin. If NOT removing the bottom fin go to Step B.
3
SETTING AND FASTENING THE DOOR
2
PREPARE THE DOOR FOR INSTALLATION
1
ROUGH OPENING PREPARATION (CONTINUED)